Kinetics of reduction step of wustite to iron of hematite and quaternary calcium ferrite mixtures

Daisuke Noguchi, Ko Ichiro Ohno, Takayuki Maeda, Kouki Nishioka, Masakata Shimizu

Research output: Contribution to journalArticle

3 Citations (Scopus)

Abstract

As a fundamental study for clarifying the reduction phenomena of sintered ore in a blast furnace, mixtures of iron oxide and quaternary calcium ferrite (Cf) were prepared and its kinetic behavior at the final stage of reduction with CO gas was studied. Reduction rate increased with increasing reduction temperature regardless of mineral ratio. Influence of mineral ratio were small and reduction rate were similar in every sample at 1000°C and above. While at 900°C and below, reduction rate increased with increaseng amount of Cf. The reason thought to be due to that the dense iron layer on surface of iron oxide particle inhibits the reduction at inner phase. Reduction reaction proceeded topochemically at higher temperature. On the other hand, reduction reaction did not proceed topochemically at lower temperature. Besides reduction reaction of rich Cf samples proceeded topochemically. Reduction data were analyzed based on the two interface unreacted core model, effective diffusion coefficient in outer layer and inner layer were determined. Reduction curves calculated by using the rate parameters obtained by the analysis agreed with observed data very well at 1000°C and above. Therefore reduction rate of two minerals mixture sample can be analyzed based on the two interface unreacted core model above 1000°C.

Original languageEnglish
Pages (from-to)55-62
Number of pages8
JournalTetsu-To-Hagane/Journal of the Iron and Steel Institute of Japan
Volume98
Issue number2
DOIs
Publication statusPublished - Feb 27 2012

Fingerprint

Hematite
hematite
Ferrite
calcium
ferrites
Calcium
Iron
iron
Kinetics
kinetics
minerals
Minerals
iron oxides
Iron oxides
ferric oxide
ferrous oxide
data reduction
blasts
furnaces
Carbon Monoxide

All Science Journal Classification (ASJC) codes

  • Condensed Matter Physics
  • Physical and Theoretical Chemistry
  • Metals and Alloys
  • Materials Chemistry

Cite this

Kinetics of reduction step of wustite to iron of hematite and quaternary calcium ferrite mixtures. / Noguchi, Daisuke; Ohno, Ko Ichiro; Maeda, Takayuki; Nishioka, Kouki; Shimizu, Masakata.

In: Tetsu-To-Hagane/Journal of the Iron and Steel Institute of Japan, Vol. 98, No. 2, 27.02.2012, p. 55-62.

Research output: Contribution to journalArticle

@article{e1ac902ef1a64e4bbbd8cbe835d08819,
title = "Kinetics of reduction step of wustite to iron of hematite and quaternary calcium ferrite mixtures",
abstract = "As a fundamental study for clarifying the reduction phenomena of sintered ore in a blast furnace, mixtures of iron oxide and quaternary calcium ferrite (Cf) were prepared and its kinetic behavior at the final stage of reduction with CO gas was studied. Reduction rate increased with increasing reduction temperature regardless of mineral ratio. Influence of mineral ratio were small and reduction rate were similar in every sample at 1000°C and above. While at 900°C and below, reduction rate increased with increaseng amount of Cf. The reason thought to be due to that the dense iron layer on surface of iron oxide particle inhibits the reduction at inner phase. Reduction reaction proceeded topochemically at higher temperature. On the other hand, reduction reaction did not proceed topochemically at lower temperature. Besides reduction reaction of rich Cf samples proceeded topochemically. Reduction data were analyzed based on the two interface unreacted core model, effective diffusion coefficient in outer layer and inner layer were determined. Reduction curves calculated by using the rate parameters obtained by the analysis agreed with observed data very well at 1000°C and above. Therefore reduction rate of two minerals mixture sample can be analyzed based on the two interface unreacted core model above 1000°C.",
author = "Daisuke Noguchi and Ohno, {Ko Ichiro} and Takayuki Maeda and Kouki Nishioka and Masakata Shimizu",
year = "2012",
month = "2",
day = "27",
doi = "10.2355/tetsutohagane.98.55",
language = "English",
volume = "98",
pages = "55--62",
journal = "Tetsu-To-Hagane/Journal of the Iron and Steel Institute of Japan",
issn = "0021-1575",
publisher = "一般社団法人 日本鉄鋼協会",
number = "2",

}

TY - JOUR

T1 - Kinetics of reduction step of wustite to iron of hematite and quaternary calcium ferrite mixtures

AU - Noguchi, Daisuke

AU - Ohno, Ko Ichiro

AU - Maeda, Takayuki

AU - Nishioka, Kouki

AU - Shimizu, Masakata

PY - 2012/2/27

Y1 - 2012/2/27

N2 - As a fundamental study for clarifying the reduction phenomena of sintered ore in a blast furnace, mixtures of iron oxide and quaternary calcium ferrite (Cf) were prepared and its kinetic behavior at the final stage of reduction with CO gas was studied. Reduction rate increased with increasing reduction temperature regardless of mineral ratio. Influence of mineral ratio were small and reduction rate were similar in every sample at 1000°C and above. While at 900°C and below, reduction rate increased with increaseng amount of Cf. The reason thought to be due to that the dense iron layer on surface of iron oxide particle inhibits the reduction at inner phase. Reduction reaction proceeded topochemically at higher temperature. On the other hand, reduction reaction did not proceed topochemically at lower temperature. Besides reduction reaction of rich Cf samples proceeded topochemically. Reduction data were analyzed based on the two interface unreacted core model, effective diffusion coefficient in outer layer and inner layer were determined. Reduction curves calculated by using the rate parameters obtained by the analysis agreed with observed data very well at 1000°C and above. Therefore reduction rate of two minerals mixture sample can be analyzed based on the two interface unreacted core model above 1000°C.

AB - As a fundamental study for clarifying the reduction phenomena of sintered ore in a blast furnace, mixtures of iron oxide and quaternary calcium ferrite (Cf) were prepared and its kinetic behavior at the final stage of reduction with CO gas was studied. Reduction rate increased with increasing reduction temperature regardless of mineral ratio. Influence of mineral ratio were small and reduction rate were similar in every sample at 1000°C and above. While at 900°C and below, reduction rate increased with increaseng amount of Cf. The reason thought to be due to that the dense iron layer on surface of iron oxide particle inhibits the reduction at inner phase. Reduction reaction proceeded topochemically at higher temperature. On the other hand, reduction reaction did not proceed topochemically at lower temperature. Besides reduction reaction of rich Cf samples proceeded topochemically. Reduction data were analyzed based on the two interface unreacted core model, effective diffusion coefficient in outer layer and inner layer were determined. Reduction curves calculated by using the rate parameters obtained by the analysis agreed with observed data very well at 1000°C and above. Therefore reduction rate of two minerals mixture sample can be analyzed based on the two interface unreacted core model above 1000°C.

UR - http://www.scopus.com/inward/record.url?scp=84857260972&partnerID=8YFLogxK

UR - http://www.scopus.com/inward/citedby.url?scp=84857260972&partnerID=8YFLogxK

U2 - 10.2355/tetsutohagane.98.55

DO - 10.2355/tetsutohagane.98.55

M3 - Article

AN - SCOPUS:84857260972

VL - 98

SP - 55

EP - 62

JO - Tetsu-To-Hagane/Journal of the Iron and Steel Institute of Japan

JF - Tetsu-To-Hagane/Journal of the Iron and Steel Institute of Japan

SN - 0021-1575

IS - 2

ER -