NASICON thick film-based CO2 sensor prepared by a sol-gel method

Tetsuya Kida, Yuji Miyachi, Kengo Shimanoe, Noboru Yamazoe

Research output: Contribution to journalArticlepeer-review

69 Citations (Scopus)

Abstract

Thick films of NASICON (Na+ conductor, Na3Zr2Si2PO12) were prepared for the fabrication of a planar CO2 sensor. The powder of a precursor of NASICON, derived through a sol-gel process, was screen-printed on an alumina substrate and converted into a NASICON thick film by calcination. The formation of crystalline NASICON was almost complete after calcination at 900 and 1000°C, but the films remained rather poor in densification. On the other hand, the films were densified after calcination at 1100°C or above, but NASICON phase disappeared by decomposition. The planar CO2 sensor device was thus fabricated by using the NASICON thick film (30μm thick) calcined at 1000°C. The device attached with a binary carbonate auxiliary phase (Li2CO3-BaCO3) showed fairly good CO2 sensing properties at 450-600°C, despite rather poor densification of the thick film used.

Original languageEnglish
Pages (from-to)28-32
Number of pages5
JournalSensors and Actuators, B: Chemical
Volume80
Issue number1
DOIs
Publication statusPublished - Nov 1 2001

All Science Journal Classification (ASJC) codes

  • Electronic, Optical and Magnetic Materials
  • Instrumentation
  • Condensed Matter Physics
  • Surfaces, Coatings and Films
  • Metals and Alloys
  • Electrical and Electronic Engineering
  • Materials Chemistry

Fingerprint

Dive into the research topics of 'NASICON thick film-based CO<sub>2</sub> sensor prepared by a sol-gel method'. Together they form a unique fingerprint.

Cite this