Si content dependence on shape memory and tensile properties in Fe-Mn-Si-C alloys

M. Koyama, T. Sawaguchi, K. Tsuzaki

Research output: Contribution to journalArticle

31 Citations (Scopus)

Abstract

Fe-17Mn-xSi-0.3C alloys (x= 0, 2, 4, 6. mass%) were used to investigate the influence of Si on the tensile properties and the shape recovery strain. We considered three kinds of tensile properties: critical stress for e{open}-martensitic transformation, critical stress for dislocation gliding, and work hardening rate. A significant increase in the shape recovery strain was obtained in the 6%Si added alloy, when the alloys were heated to 873. K after a pre-straining of 8% in tension. The critical stresses for both the e{open}-martensitic transformation and the dislocation gliding increased with an increase in Si content from 0 to 4% but were similar in the 4%Si and 6%Si added alloys. However, the work hardening rate between the 4%Si and 6%Si added alloys was significantly different and was much smaller in the 6%Si added alloy. Hence, a 6%Si addition suppresses the plastic deformation due to the dislocation gliding through the decrease in the work hardening rate along with the solution hardening. As a result, e{open}-martensitic transformation occurs as the predominant deformation mode at smaller strains and improves the shape recovery strain.

Original languageEnglish
Pages (from-to)2882-2888
Number of pages7
JournalMaterials Science and Engineering A
Volume528
Issue number6
DOIs
Publication statusPublished - Mar 15 2011

All Science Journal Classification (ASJC) codes

  • Materials Science(all)
  • Condensed Matter Physics
  • Mechanics of Materials
  • Mechanical Engineering

Fingerprint Dive into the research topics of 'Si content dependence on shape memory and tensile properties in Fe-Mn-Si-C alloys'. Together they form a unique fingerprint.

  • Cite this