Soot formation characteristics in a lab-scale turbulent pulverized coal flame with simultaneous planar measurements of laser induced incandescence of soot and Mie scattering of pulverized coal

Jun Hayashi, Nozomu Hashimoto, Noriaki Nakatsuka, Hirofumi Tsuji, Hiroaki Watanabe, Hisao Makino, Fumiteru Akamatsu

Research output: Contribution to journalArticle

32 Citations (Scopus)

Abstract

Soot formation characteristics of a lab-scale pulverized coal flame were investigated by performing carefully controlled laser diagnostics. The spatial distributions of soot volume fraction and the pulverized coal particles were measured simultaneously by laser induced incandescence (LII) and Mie scattering imaging, respectively. In addition, the radial distributions of the soot volume fraction were compared with the OH radical fluorescence, gas temperature and oxygen concentration obtained in our previous studies [1,2]. The results indicated that the laser pulse fluence used for LII measurement should be carefully controlled to measure the soot volume fraction in pulverized coal flames. To precisely measure the soot volume fraction in pulverized coal flames using LII, it is necessary to adjust the laser pulse fluence so that it is sufficiently high to heat up all the soot particles to the sublimation temperature but also sufficiently low to avoid including a too large of a change in the morphology of the soot particles and the superposition of the LII signal from the pulverized coal particles on that from the soot particles. It was also found that the radial position of the peak LII signal intensity was located between the positions of the peak Mie scattering signal intensity and peak OH radical signal intensity. The region, in which LII signal, OH radical fluorescence and Mie scattering coexisted, expanded with increasing height above the burner port. It was also found that the soot formation in pulverized coal flames was enhanced at locations where the conditions of high temperature, low oxygen concentration and the existence of pulverized coal particles were satisfied simultaneously.

Original languageEnglish
Pages (from-to)2435-2443
Number of pages9
JournalProceedings of the Combustion Institute
Volume34
Issue number2
DOIs
Publication statusPublished - Jan 11 2013
Externally publishedYes

Fingerprint

incandescence
Soot
Coal
Mie scattering
soot
coal
flames
Scattering
Lasers
scattering
lasers
Volume fraction
Laser pulses
fluence
Fluorescence
Laser diagnostics
Oxygen
fluorescence
Sublimation
burners

All Science Journal Classification (ASJC) codes

  • Chemical Engineering(all)
  • Mechanical Engineering
  • Physical and Theoretical Chemistry

Cite this

Soot formation characteristics in a lab-scale turbulent pulverized coal flame with simultaneous planar measurements of laser induced incandescence of soot and Mie scattering of pulverized coal. / Hayashi, Jun; Hashimoto, Nozomu; Nakatsuka, Noriaki; Tsuji, Hirofumi; Watanabe, Hiroaki; Makino, Hisao; Akamatsu, Fumiteru.

In: Proceedings of the Combustion Institute, Vol. 34, No. 2, 11.01.2013, p. 2435-2443.

Research output: Contribution to journalArticle

@article{0a2ea65f8b6044a290b709d213cf21b8,
title = "Soot formation characteristics in a lab-scale turbulent pulverized coal flame with simultaneous planar measurements of laser induced incandescence of soot and Mie scattering of pulverized coal",
abstract = "Soot formation characteristics of a lab-scale pulverized coal flame were investigated by performing carefully controlled laser diagnostics. The spatial distributions of soot volume fraction and the pulverized coal particles were measured simultaneously by laser induced incandescence (LII) and Mie scattering imaging, respectively. In addition, the radial distributions of the soot volume fraction were compared with the OH radical fluorescence, gas temperature and oxygen concentration obtained in our previous studies [1,2]. The results indicated that the laser pulse fluence used for LII measurement should be carefully controlled to measure the soot volume fraction in pulverized coal flames. To precisely measure the soot volume fraction in pulverized coal flames using LII, it is necessary to adjust the laser pulse fluence so that it is sufficiently high to heat up all the soot particles to the sublimation temperature but also sufficiently low to avoid including a too large of a change in the morphology of the soot particles and the superposition of the LII signal from the pulverized coal particles on that from the soot particles. It was also found that the radial position of the peak LII signal intensity was located between the positions of the peak Mie scattering signal intensity and peak OH radical signal intensity. The region, in which LII signal, OH radical fluorescence and Mie scattering coexisted, expanded with increasing height above the burner port. It was also found that the soot formation in pulverized coal flames was enhanced at locations where the conditions of high temperature, low oxygen concentration and the existence of pulverized coal particles were satisfied simultaneously.",
author = "Jun Hayashi and Nozomu Hashimoto and Noriaki Nakatsuka and Hirofumi Tsuji and Hiroaki Watanabe and Hisao Makino and Fumiteru Akamatsu",
year = "2013",
month = "1",
day = "11",
doi = "10.1016/j.proci.2012.10.002",
language = "English",
volume = "34",
pages = "2435--2443",
journal = "Proceedings of the Combustion Institute",
issn = "1540-7489",
publisher = "Elsevier Limited",
number = "2",

}

TY - JOUR

T1 - Soot formation characteristics in a lab-scale turbulent pulverized coal flame with simultaneous planar measurements of laser induced incandescence of soot and Mie scattering of pulverized coal

AU - Hayashi, Jun

AU - Hashimoto, Nozomu

AU - Nakatsuka, Noriaki

AU - Tsuji, Hirofumi

AU - Watanabe, Hiroaki

AU - Makino, Hisao

AU - Akamatsu, Fumiteru

PY - 2013/1/11

Y1 - 2013/1/11

N2 - Soot formation characteristics of a lab-scale pulverized coal flame were investigated by performing carefully controlled laser diagnostics. The spatial distributions of soot volume fraction and the pulverized coal particles were measured simultaneously by laser induced incandescence (LII) and Mie scattering imaging, respectively. In addition, the radial distributions of the soot volume fraction were compared with the OH radical fluorescence, gas temperature and oxygen concentration obtained in our previous studies [1,2]. The results indicated that the laser pulse fluence used for LII measurement should be carefully controlled to measure the soot volume fraction in pulverized coal flames. To precisely measure the soot volume fraction in pulverized coal flames using LII, it is necessary to adjust the laser pulse fluence so that it is sufficiently high to heat up all the soot particles to the sublimation temperature but also sufficiently low to avoid including a too large of a change in the morphology of the soot particles and the superposition of the LII signal from the pulverized coal particles on that from the soot particles. It was also found that the radial position of the peak LII signal intensity was located between the positions of the peak Mie scattering signal intensity and peak OH radical signal intensity. The region, in which LII signal, OH radical fluorescence and Mie scattering coexisted, expanded with increasing height above the burner port. It was also found that the soot formation in pulverized coal flames was enhanced at locations where the conditions of high temperature, low oxygen concentration and the existence of pulverized coal particles were satisfied simultaneously.

AB - Soot formation characteristics of a lab-scale pulverized coal flame were investigated by performing carefully controlled laser diagnostics. The spatial distributions of soot volume fraction and the pulverized coal particles were measured simultaneously by laser induced incandescence (LII) and Mie scattering imaging, respectively. In addition, the radial distributions of the soot volume fraction were compared with the OH radical fluorescence, gas temperature and oxygen concentration obtained in our previous studies [1,2]. The results indicated that the laser pulse fluence used for LII measurement should be carefully controlled to measure the soot volume fraction in pulverized coal flames. To precisely measure the soot volume fraction in pulverized coal flames using LII, it is necessary to adjust the laser pulse fluence so that it is sufficiently high to heat up all the soot particles to the sublimation temperature but also sufficiently low to avoid including a too large of a change in the morphology of the soot particles and the superposition of the LII signal from the pulverized coal particles on that from the soot particles. It was also found that the radial position of the peak LII signal intensity was located between the positions of the peak Mie scattering signal intensity and peak OH radical signal intensity. The region, in which LII signal, OH radical fluorescence and Mie scattering coexisted, expanded with increasing height above the burner port. It was also found that the soot formation in pulverized coal flames was enhanced at locations where the conditions of high temperature, low oxygen concentration and the existence of pulverized coal particles were satisfied simultaneously.

UR - http://www.scopus.com/inward/record.url?scp=84872013612&partnerID=8YFLogxK

UR - http://www.scopus.com/inward/citedby.url?scp=84872013612&partnerID=8YFLogxK

U2 - 10.1016/j.proci.2012.10.002

DO - 10.1016/j.proci.2012.10.002

M3 - Article

VL - 34

SP - 2435

EP - 2443

JO - Proceedings of the Combustion Institute

JF - Proceedings of the Combustion Institute

SN - 1540-7489

IS - 2

ER -