A new way of analyzing occlusion 3 dimensionally

Haruaki Hayasaki, Renato Parsekian Martins, Luiz Gonzaga Gandini, Issei Saitoh, Kazuaki Nonaka

研究成果: Contribution to journalArticle査読

20 被引用数 (Scopus)

抄録

This article introduces a new method for 3-dimensional dental cast analysis, by using a mechanical 3-dimensional digitizer, MicroScribe 3DX (Immersion, San Jose, Calif), and TIGARO software (not yet released, but available from the author at hayasaki@dent.kyushu-u.ac.jp). By digitizing points on the model, multiple measurements can be made, including tooth dimensions; arch length, width, and perimeter; curve of Spee; overjet and overbite; and anteroposterior discrepancy. The bias of the system can be evaluated by comparing the distance between 2 points as determined by the new system and as measured with digital calipers. Fifteen pairs of models were measured digitally and manually, and the bias was evaluated by comparing the variances of both methods and checking for the type of error obtained by each method. No systematic errors were found. The results showed that the method is accurate, and it can be applied to both clinical practice and research.

本文言語英語
ページ(範囲)128-132
ページ数5
ジャーナルAmerican Journal of Orthodontics and Dentofacial Orthopedics
128
1
DOI
出版ステータス出版済み - 7 1 2005

All Science Journal Classification (ASJC) codes

  • Orthodontics

フィンガープリント 「A new way of analyzing occlusion 3 dimensionally」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル