Additive manufacturing based on injection molding for three dimensional microfluidics

T. Naito, M. Nakamura, T. Kubo, T. Yasui, N. Kaji, Y. Baba, K. Otuska

研究成果: Chapter in Book/Report/Conference proceedingConference contribution

抄録

This paper describes three dimensional (3D) microfluidic devices fabricated by an injection molding-based additive manufacturing with standard equipment for soft-lithography. The method achieves 3D fabrication without specific instruments or water-soluble support material. It provides the same level of minimum membrane thickness as a high end model commercial 3D printer, and the bond strength between the membranes have a sufficient pressure resistance to the flow of water with a syringe pump. Finally, two types of 3D microstructures were fabricated by the method: the 3D fractal structure called Menger sponge, and a channel within a channel structure for 3D sheath flow.

本文言語英語
ホスト出版物のタイトル18th International Conference on Miniaturized Systems for Chemistry and Life Sciences, MicroTAS 2014
出版社Chemical and Biological Microsystems Society
ページ1686-1688
ページ数3
ISBN(電子版)9780979806476
出版ステータス出版済み - 1 1 2014
外部発表はい
イベント18th International Conference on Miniaturized Systems for Chemistry and Life Sciences, MicroTAS 2014 - San Antonio, 米国
継続期間: 10 26 201410 30 2014

その他

その他18th International Conference on Miniaturized Systems for Chemistry and Life Sciences, MicroTAS 2014
国/地域米国
CitySan Antonio
Period10/26/1410/30/14

All Science Journal Classification (ASJC) codes

  • 制御およびシステム工学

フィンガープリント

「Additive manufacturing based on injection molding for three dimensional microfluidics」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル