Decreased sintering temperature of anode-supported solid oxide fuel cells with La-doped CeO2 and Sr- and Mg-doped LaGaO3 films by Co addition

Jong Eun Hong, Shintaro Ida, Tatsumi Ishihara

    研究成果: Contribution to journalArticle査読

    9 被引用数 (Scopus)

    抄録

    Effects of decrease in sintering temperature (1473-1623 K) on the electrochemical performance of anode-supported solid oxide fuel cells (SOFCs) were investigated using Sr- and Mg-doped LaGaO3 (LSGM) electrolyte film while using La-doped CeO2 with Co addition (Co-LDC) as the buffer layer. The sintering temperature of the single cell was reduced to 1523 K by the use of Co-LDC buffer layer. The cell showed maximum power density (MPD) of ∼1 W cm-2 and an open circuit voltage (OCV) close to the theoretical value at 973 K, which was comparable with previous results for cells prepared by sintering at 1673 K. The cell performance was further improved with increasing the sintering temperature because of the reduced internal resistances, and it was stable after operation for 92 h at 973 K, suggesting that the Co-LDC buffer layer posed no detrimental effect. Thus, Co-LDC is a promising buffer layer for LSGM electrolyte film prepared by wet coating and cosintering processes to improve the performance of anode-supported SOFCs.

    本文言語英語
    ページ(範囲)282-288
    ページ数7
    ジャーナルJournal of Power Sources
    259
    DOI
    出版ステータス出版済み - 8 1 2014

    All Science Journal Classification (ASJC) codes

    • Renewable Energy, Sustainability and the Environment
    • Energy Engineering and Power Technology
    • Physical and Theoretical Chemistry
    • Electrical and Electronic Engineering

    フィンガープリント 「Decreased sintering temperature of anode-supported solid oxide fuel cells with La-doped CeO<sub>2</sub> and Sr- and Mg-doped LaGaO<sub>3</sub> films by Co addition」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

    引用スタイル