Development of a high-strength high-conductivity Cu-Ni-P alloy. Part I: Characterization of precipitation products

M. Murayama, A. Belyakov, T. Hara, Y. Sakai, K. Tsuzaki, M. Okubo, M. Eto, T. Kimura

研究成果: ジャーナルへの寄稿学術誌査読

18 被引用数 (Scopus)

抄録

The precipitation products of a Cu-1.5Ni-0.32P (wt.%) alloy isochronally aged at 400°C and 600°C were investigated by transmission electron microscopy (TEM). There are two different sizes of precipitates formed in the 600°C aged specimen. Large precipitates appear to be lath, the length of which varies from 100 nm to 500 nm, whereas small dotty contrasts around 10 nm in diameter are uniformly distributed in the matrix. Only small dotty contrasts are observed after 400°C aging. In the composition range 0-33.3 at.%P, both the previous studies and the calculated Ni-P binary phase diagram indicated that the possible nickel phosphide phases are Ni3P, Ni12P 5, Ni5P2, and Ni2P. However, selected area electron diffraction (SAED) pattern analysis in conjunction with energy dispersive x-ray spectroscopy (EDS) identified the large lath precipitates as Ni12P5 phase. On the other hand, the small precipitates could not be analyzed by EDS due to thinness; thus, the structure is estimated to be a Ni5P4 phase from the relationships between d-spacing and angles between planes measured from a selected area diffraction pattern.

本文言語英語
ページ(範囲)1787-1792
ページ数6
ジャーナルJournal of Electronic Materials
35
10
DOI
出版ステータス出版済み - 10月 2006

!!!All Science Journal Classification (ASJC) codes

  • 電子材料、光学材料、および磁性材料
  • 凝縮系物理学
  • 電子工学および電気工学
  • 材料化学

フィンガープリント

「Development of a high-strength high-conductivity Cu-Ni-P alloy. Part I: Characterization of precipitation products」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル