Effect of CO gas concentration on reduction rate of major mineral phase in sintered iron ore

Daisuke Noguchi, Ko-Ichiro Ohno, Takayuki Maeda, Kouki Nishioka, Masakata Shimizu

研究成果: ジャーナルへの寄稿記事

4 引用 (Scopus)

抄録

As a fundamental study for clarifying the reduction phenomena of sintered iron ore in a blast furnace, iron oxide (H) and quaternary calcium ferrite (Cf) were prepared and its kinetic behavior at the final stage of reduction with CO-CO2 gas mixture was studied. Reduction rate increased with increasing reduction temperature. Besides, it inc reased with increasing partial pressure of CO gas. Influence of gas composition on reduction rate is much larger than reduction temperature. From comparisons of weight loss curves of H samples with that of Cf samples, reduction rate of H samples were fast er than that of Cf samples in the same conditions. Reduction reaction of H and Cf samples proceeded topochemically at higher temperature (1100°C), and proceeded non-topochemically at lower temperature (<1000° C). Besides, the reduction reaction of sam ples used CO rich gas proceeded topochemically. Structure of iron layer in H samples were different for temperature and gas composition. On the other hand, structure of iron layer in Cf samples were almost the same in all conditions. Reduction data were a nalyzed by one interface unreacted core model, chemical reaction rate content kc and effective diffusion coefficient in product layer De were determined. The values of kc had Arrhenius-type temperature dependence, and were approximately same tendency except for Cf samples in near equilibriums gas compositions. The values of De obtained from Cf samples were approximately constant in all conditions.

元の言語英語
ページ(範囲)548-553
ページ数6
ジャーナルTetsu-To-Hagane/Journal of the Iron and Steel Institute of Japan
97
発行部数11
DOI
出版物ステータス出版済み - 11 17 2011

Fingerprint

iron ores
Iron ores
Carbon Monoxide
Minerals
Gases
minerals
Ferrite
calcium
ferrites
Calcium
gases
gas composition
Temperature
Iron
Chemical analysis
iron
data reduction
blasts
Blast furnaces
Iron oxides

All Science Journal Classification (ASJC) codes

  • Condensed Matter Physics
  • Physical and Theoretical Chemistry
  • Metals and Alloys
  • Materials Chemistry

これを引用

Effect of CO gas concentration on reduction rate of major mineral phase in sintered iron ore. / Noguchi, Daisuke; Ohno, Ko-Ichiro; Maeda, Takayuki; Nishioka, Kouki; Shimizu, Masakata.

:: Tetsu-To-Hagane/Journal of the Iron and Steel Institute of Japan, 巻 97, 番号 11, 17.11.2011, p. 548-553.

研究成果: ジャーナルへの寄稿記事

@article{a7ca47c5183f45f48f60a8ed27defd89,
title = "Effect of CO gas concentration on reduction rate of major mineral phase in sintered iron ore",
abstract = "As a fundamental study for clarifying the reduction phenomena of sintered iron ore in a blast furnace, iron oxide (H) and quaternary calcium ferrite (Cf) were prepared and its kinetic behavior at the final stage of reduction with CO-CO2 gas mixture was studied. Reduction rate increased with increasing reduction temperature. Besides, it inc reased with increasing partial pressure of CO gas. Influence of gas composition on reduction rate is much larger than reduction temperature. From comparisons of weight loss curves of H samples with that of Cf samples, reduction rate of H samples were fast er than that of Cf samples in the same conditions. Reduction reaction of H and Cf samples proceeded topochemically at higher temperature (1100°C), and proceeded non-topochemically at lower temperature (<1000° C). Besides, the reduction reaction of sam ples used CO rich gas proceeded topochemically. Structure of iron layer in H samples were different for temperature and gas composition. On the other hand, structure of iron layer in Cf samples were almost the same in all conditions. Reduction data were a nalyzed by one interface unreacted core model, chemical reaction rate content kc and effective diffusion coefficient in product layer De were determined. The values of kc had Arrhenius-type temperature dependence, and were approximately same tendency except for Cf samples in near equilibriums gas compositions. The values of De obtained from Cf samples were approximately constant in all conditions.",
author = "Daisuke Noguchi and Ko-Ichiro Ohno and Takayuki Maeda and Kouki Nishioka and Masakata Shimizu",
year = "2011",
month = "11",
day = "17",
doi = "10.2355/tetsutohagane.97.548",
language = "English",
volume = "97",
pages = "548--553",
journal = "Tetsu-To-Hagane/Journal of the Iron and Steel Institute of Japan",
issn = "0021-1575",
publisher = "一般社団法人 日本鉄鋼協会",
number = "11",

}

TY - JOUR

T1 - Effect of CO gas concentration on reduction rate of major mineral phase in sintered iron ore

AU - Noguchi, Daisuke

AU - Ohno, Ko-Ichiro

AU - Maeda, Takayuki

AU - Nishioka, Kouki

AU - Shimizu, Masakata

PY - 2011/11/17

Y1 - 2011/11/17

N2 - As a fundamental study for clarifying the reduction phenomena of sintered iron ore in a blast furnace, iron oxide (H) and quaternary calcium ferrite (Cf) were prepared and its kinetic behavior at the final stage of reduction with CO-CO2 gas mixture was studied. Reduction rate increased with increasing reduction temperature. Besides, it inc reased with increasing partial pressure of CO gas. Influence of gas composition on reduction rate is much larger than reduction temperature. From comparisons of weight loss curves of H samples with that of Cf samples, reduction rate of H samples were fast er than that of Cf samples in the same conditions. Reduction reaction of H and Cf samples proceeded topochemically at higher temperature (1100°C), and proceeded non-topochemically at lower temperature (<1000° C). Besides, the reduction reaction of sam ples used CO rich gas proceeded topochemically. Structure of iron layer in H samples were different for temperature and gas composition. On the other hand, structure of iron layer in Cf samples were almost the same in all conditions. Reduction data were a nalyzed by one interface unreacted core model, chemical reaction rate content kc and effective diffusion coefficient in product layer De were determined. The values of kc had Arrhenius-type temperature dependence, and were approximately same tendency except for Cf samples in near equilibriums gas compositions. The values of De obtained from Cf samples were approximately constant in all conditions.

AB - As a fundamental study for clarifying the reduction phenomena of sintered iron ore in a blast furnace, iron oxide (H) and quaternary calcium ferrite (Cf) were prepared and its kinetic behavior at the final stage of reduction with CO-CO2 gas mixture was studied. Reduction rate increased with increasing reduction temperature. Besides, it inc reased with increasing partial pressure of CO gas. Influence of gas composition on reduction rate is much larger than reduction temperature. From comparisons of weight loss curves of H samples with that of Cf samples, reduction rate of H samples were fast er than that of Cf samples in the same conditions. Reduction reaction of H and Cf samples proceeded topochemically at higher temperature (1100°C), and proceeded non-topochemically at lower temperature (<1000° C). Besides, the reduction reaction of sam ples used CO rich gas proceeded topochemically. Structure of iron layer in H samples were different for temperature and gas composition. On the other hand, structure of iron layer in Cf samples were almost the same in all conditions. Reduction data were a nalyzed by one interface unreacted core model, chemical reaction rate content kc and effective diffusion coefficient in product layer De were determined. The values of kc had Arrhenius-type temperature dependence, and were approximately same tendency except for Cf samples in near equilibriums gas compositions. The values of De obtained from Cf samples were approximately constant in all conditions.

UR - http://www.scopus.com/inward/record.url?scp=81055144734&partnerID=8YFLogxK

UR - http://www.scopus.com/inward/citedby.url?scp=81055144734&partnerID=8YFLogxK

U2 - 10.2355/tetsutohagane.97.548

DO - 10.2355/tetsutohagane.97.548

M3 - Article

VL - 97

SP - 548

EP - 553

JO - Tetsu-To-Hagane/Journal of the Iron and Steel Institute of Japan

JF - Tetsu-To-Hagane/Journal of the Iron and Steel Institute of Japan

SN - 0021-1575

IS - 11

ER -