Effects of ultrasonic vibration on machining accuracy in microdrilling

Hiromichi Onikura, Osamu Ohnishi, Jinhai Feng, Toshikazu Kanda, Takehiro Morita, Urs Bopp

    研究成果: ジャーナルへの寄稿学術誌査読

    24 被引用数 (Scopus)

    抄録

    The purposes of the present paper are to investigate the effects of ultrasonic vibration on machining accuracy of duralumin and to clarify the mechanisms for the improvement of machining accuracy in microdrilling. Ultrasonic vibration of 40 kHz considerably reduces the friction on the rake face, makes chips thinner and then decreases cutting forces. This decrease in cutting forces, especially the mean radial force, leads to the improvement of cutting accuracy, i. e. smaller hole oversize, a little better roundness at hole entrance and smaller displacement of hole center under ultrasonic vibration. The thinner chip increases the velocity of chip flow and results in better characteristics of chip disposal and less tendency of drill breakage.

    本文言語英語
    ページ(範囲)210-216
    ページ数7
    ジャーナルInternational Journal of the Japan Society for Precision Engineering
    30
    3
    出版ステータス出版済み - 9月 1 1996

    !!!All Science Journal Classification (ASJC) codes

    • 工学(全般)

    フィンガープリント

    「Effects of ultrasonic vibration on machining accuracy in microdrilling」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

    引用スタイル