Estimation of cavity length in EHL rolling point contact

K. Stadler, N. Izumi, T. Morita, J. Sugimura, B. Piccigallo

    研究成果: ジャーナルへの寄稿学術誌査読

    8 被引用数 (Scopus)

    抄録

    Reciprocating lubricated contacts sometimes suffer from oil starvation due to cavitation at the reversal of motion. However, the behavior of cavities is not well understood such that starvation can be theoretically predicted. In this study, the length of cavity in a steady state elastohydrodynamic lubricated point contact was calculated. For numerical simulation, a modified Elrod algorithm was used. An equation was obtained for the cavity enclosed in the oil meniscus. The equation was constructed with Moes dimensionless parameters M and L, assumed pressure of cavity, and viscosity pressure index of the lubricant. The dimensionless cavity length (or the ratio of cavity length by Hertzian contact radius) is proportional to the product of M-a and Lb. Careful examination of the equation elucidated that the cavity length is dominated by the viscosity, sum velocity, cavity pressure, and geometry of the contact. Experimental measurements with a ball-on-disk apparatus have shown good agreement. The validity of the equation suggests that the algorithm is applicable for complete transient simulations. In practice, the estimated cavity length can be a parameter for starvation.

    本文言語英語
    ページ(範囲)315021-315029
    ページ数9
    ジャーナルJournal of Tribology
    130
    3
    出版ステータス出版済み - 7月 1 2008

    !!!All Science Journal Classification (ASJC) codes

    • 材料力学
    • 機械工学
    • 表面および界面
    • 表面、皮膜および薄膜

    フィンガープリント

    「Estimation of cavity length in EHL rolling point contact」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

    引用スタイル