Fabrication and morphological control of ion-induced zinc nanostructures

Pradip Ghosh, Masaki Kutsuna, Masato Kudo, Akari Hayashi, Yasuhiko Hayashi, Masaki Tanemura

研究成果: ジャーナルへの寄稿学術誌査読

抄録

An efficient method for the fabrication of zinc (Zn) nanostructures (nanoneedles and nanofibers) of controllable density and morphology without any catalyst, hazardous chemicals or external heat supply has been investigated. By varying the ion irradiation time and the ion current density, morphological control and the density of Zn nanostructures were successfully achieved using a fast and viable ion irradiation technique. Scanning (SEM) and transmission electron microscopy (TEM) results revealed that the sputtered surface was almost entirely covered with densely distributed conical and needle-like protrusions with linear shaped (sometimes curved) nanostructures (such as nanoneedles and nanofibers) with diameters and lengths of about 20-50 nm and several hundred nanometers, respectively. Detailed analysis of selected area electron diffraction (SAED) patterns with TEM analysis indicates that the Zn nanofibers were polycrystalline in nature. A possible mechanism of the formation of Zn nanostructures is briefly discussed. These aligned arrays of Zn nanoneedles/nanofibers could be a promising material for the fabrication of zinc oxide nanostructures by subsequent oxidation of Zn nanostructures and their future application in nanodevices. Thus, it is believed that this ion irradiation technique could open up a new approach for the fabrication of many kinds of nanomaterials of controllable density.

本文言語英語
ページ(範囲)6677-6682
ページ数6
ジャーナルJournal of nanoscience and nanotechnology
10
10
DOI
出版ステータス出版済み - 10月 1 2010
外部発表はい

!!!All Science Journal Classification (ASJC) codes

  • バイオエンジニアリング
  • 化学 (全般)
  • 生体医工学
  • 材料科学(全般)
  • 凝縮系物理学

フィンガープリント

「Fabrication and morphological control of ion-induced zinc nanostructures」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル