Fabrication of TiNi/CFRP smart composite using cold drawn TiNi wires

Ya Xu, Kazuhiro Otsuka, Nobuyuki Toyama, Hitoshi Yoshida, Byung K. Jang, Hideki Nagai, Ryutaro Oishi, Teruo Kishi

研究成果: ジャーナルへの寄稿学術誌査読

3 被引用数 (Scopus)

抄録

In recent years, pre-strained TiNi shape memory alloys (SMA) have been used for fabricating smart structure with carbon fibers reinforced plastics (CFRP) in order to suppress microscopic mechanical damages. However, since the cure temperature of CFRP is higher than the reverse transformation temperatures of TiNi SMA, special fixture jigs have to be used for keeping the pre-strain during fabrication, which restricted its practical application. In order to overcome this difficulty, we developed a new method to fabricate SMA/CFRP smart composites without using special fixture jigs by controlling the transformation temperatures of SMA during fabrication. This method consists of using heavily cold-worked wires to increase the reverse transformation temperatures, and of using flash electrical heating of the wires after fabrication in order to decrease the reverse transformation temperatures to a lower temperature range again without damaging the epoxy resin around SMA wires. By choosing proper cold-working rate and composition of TiNi alloys, the reverse transformation temperatures were well controlled, and the TiNi/CFRP hybrid smart composite was fabricated without using special fixture jigs. The damage suppressing effect of cold drawn wires embedded in CFRP was confirmed.

本文言語英語
ページ(範囲)564-574
ページ数11
ジャーナルProceedings of SPIE-The International Society for Optical Engineering
4699
DOI
出版ステータス出版済み - 1月 1 2002
外部発表はい

!!!All Science Journal Classification (ASJC) codes

  • 電子材料、光学材料、および磁性材料
  • 凝縮系物理学
  • コンピュータ サイエンスの応用
  • 応用数学
  • 電子工学および電気工学

フィンガープリント

「Fabrication of TiNi/CFRP smart composite using cold drawn TiNi wires」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル