Fatigue strength properties of precipitation strengthening stainless steel A286 focused attention on small fatigue crack behaviour

H. Wu, Y. Oshida, S. Hamada, H. Noguchi

研究成果: Contribution to journalArticle査読

6 被引用数 (Scopus)

抄録

In order to safely use precipitation strengthening type A286 stainless steel in high cycles, the fundamental fatigue strength characteristics were investigated using fatigue tests at room temperature. During the fatigue test, the author paid attention to the behaviour of small fatigue cracks in order to clarify the fatigue strength properties in more detail than the usual fatigue test. As a result of the fatigue test, the fatigue strength characteristic of the A286 steel became clarified as shown below. The fatigue strength ratio of the A286 steel is lower than 0. 5 which is the ratio value of most steels. The cracks propagate which result in a failure even after 107 cycles. It was found that there are two crack mechanisms propagation of the A286 steel; i.e., in a high load-stress, the cracks monotonously propagate and result in failure. Under a low load-stress, the cracks intermittently propagate even after 107 cycles. The non-propagating cracks coalesce with a new crack which initiates near the crack tip and it becomes longer, finally resulting in a failure. This is the reason why the fatigue failures occur even after 10 7 cycles.

本文言語英語
ページ(範囲)1973-1978
ページ数6
ジャーナルProcedia Engineering
10
DOI
出版ステータス出版済み - 2011

All Science Journal Classification (ASJC) codes

  • 工学(全般)

フィンガープリント

「Fatigue strength properties of precipitation strengthening stainless steel A286 focused attention on small fatigue crack behaviour」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル