Heat-transfer characteristics during rapid quenching of a thin wire in water

Hiroshi Honda, Hiroshi Takamatsu, Hikaru Yamashiro, Shintaro Kobayashi

研究成果: Contribution to journalArticle査読

15 被引用数 (Scopus)

抄録

Rapid quenching of thin horizontal platinum wires (0.3 and 0.5 mm in diameter) was studied experimentally using pure water as the quenching liquid. The cooling curve was obtained in the ranges of water temperature of 0 to 50 °C, falling velocity of the wire of 0.1 to 1.5 m/s, and initial wire temperature of 600 to 1400 °C. Boiling curves for the rapid quenching process were obtained from the cooling curve. The degree of superheat at the minimum heat flux point was around 350 K irrespective of the water temperature, the falling velocity, and the wire diameter. The heat fluxes in the film, transition, and nucleate boiling regions increased with increasing degree of subcooling and falling velocity. A numerical analysis of transient film boiling on a horizontal cylinder with upward liquid flow was performed. The measured meat flux was about 30 percent higher than the calculated value at the forward stagnation point.

本文言語英語
ページ(範囲)773-791
ページ数19
ジャーナルHeat Transfer - Japanese Research
21
8
出版ステータス出版済み - 12 1 1992

All Science Journal Classification (ASJC) codes

  • Fluid Flow and Transfer Processes

フィンガープリント 「Heat-transfer characteristics during rapid quenching of a thin wire in water」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル