In-process tool flank wear detection in intermittent cutting process by face milling

Mitsuaki Murata, Syuhei Kurokawa, Osamu Ohnishi, Michio Uneda, Toshiro Doi

研究成果: Contribution to conferencePaper査読

抄録

This paper reports in-process detection of tool wear by using tool-work thermo-electromotive force (E.M.F.) as a sensor signal in face milling. In the case of using a single cutting edge, E.M.F. at the beginning of cut increased slowly corresponding to the width of tool flank wear. We assume this phenomenon is due to variations in electric resistance by increase of the contact area between the workpiece and the tool, so electric current between tool and workpiece was also detected. The variations of contact electric resistance calculated from both the E.M.F. and the electric current reveal that the electric resistance decreases as the tool flank wear progresses because contact areas between tool and workpiece increase. We developed a measurement system of variations of the contact resistance during face milling process. By monitorng the contact resistance using this system, the realtime detection of the width of tool fank wear can be achieved stably during cutting operations.

本文言語英語
出版ステータス出版済み - 12 1 2011
イベント6th International Conference on Leading Edge Manufacturing in 21st Century, LEM 2011 - Omiya Sonic City, Saitama, 日本
継続期間: 11 8 201111 10 2011

その他

その他6th International Conference on Leading Edge Manufacturing in 21st Century, LEM 2011
Country日本
CityOmiya Sonic City, Saitama
Period11/8/1111/10/11

All Science Journal Classification (ASJC) codes

  • Industrial and Manufacturing Engineering

フィンガープリント 「In-process tool flank wear detection in intermittent cutting process by face milling」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル