Laser sintering and lamination characteristics of Fe-Cu atomized powders

Katsuhiro Maekawa, Terutake Hayashi, Yasuo Sato, Kazumi Minagawa, Hideki Kakisawa

研究成果: Contribution to journalArticle査読

抄録

Sintering and lamination characteristics of Fe-Cu atomized powder have been investigated to meet requirements on recycling of automobiles and manufacture of lightweight structure. The greentape laser sintering method using Nd:YAG pulse laser and powder tape called "greentape" is employed for the fabrication of Fe-Cu porous structure. Extensively investigated is influence of laser parameters, such as voltage, pulse width and average power upon the state of liquid sintering or both surface texture and tensile strength of the sintered specimens. A water-atomized Fe-5mass%Cu powder (3-8/μm in diameter) is superior to the gas-atomized Fe-2mass%Cu one (5-38/μm) in monolayer strength, but being difficult to laminate due to the existence of massive pores. It is successful to laminate 16 layers of gas-atomized greentape (190μm in thickness each) at a voltage of 198 V, a pulse width of 2.0 ms and an average power of 13 W. Porous structure can be controlled by changing these laser parameters, whereas it is necessary to resolve distortion of the sintered part by means of a segmented laser irradiation.

本文言語英語
ページ(範囲)749-755
ページ数7
ジャーナルFuntai Oyobi Fummatsu Yakin/Journal of the Japan Society of Powder and Powder Metallurgy
51
10
DOI
出版ステータス出版済み - 10 2004
外部発表はい

All Science Journal Classification (ASJC) codes

  • 機械工学
  • 産業および生産工学
  • 金属および合金
  • 材料化学

フィンガープリント

「Laser sintering and lamination characteristics of Fe-Cu atomized powders」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル