Micro-computed tomography analysis of early stage bone healing using micro-porous titanium mesh for guided bone regeneration

preliminary experiment in a canine model

Yunia Dwi Rakhmatia, Yasunori Ayukawa, Yohei Jinno, Akihiro Furuhashi, Kiyoshi Koyano

研究成果: ジャーナルへの寄稿記事

8 引用 (Scopus)

抄録

The aim of this study was to evaluate the amount of bone formation beneath a defect area after treatment with titanium mesh membranes with different thicknesses and pore sizes alone or in combination with bone graft to induce bone formation during the early stage of healing time. The mandibular premolars were extracted bilaterally from three adult beagle dogs, and 8-mm-diameter bone defects were created on the buccal site of the premolar regions. Hydroxyapatite bone graft substitute was applied in the defect site unilaterally, and other site was left empty. Then, a novel micro-porous mesh (50 μm in pore diameter) or commercially available macro-porous titanium mesh (1700 μm in pore diameter) was placed on the defect and secured with screws. After 4 weeks, the mandibles were harvested, imaged using micro-computed tomography, and prepared for histological and morphometric evaluation. Higher new bone volumes (mm3), percentage of new bone volumes in the total defect volumes (bone ratio: %), and new bone area (mm2) through morphometric evaluation were found on the novel membranes with 50-μm-diameter pores compared to the commercial titanium mesh. Moreover, experiment sites without bone graft were observed with higher new bone volume and bone ratio compared with sites with bone graft. However, bone mineral density of novel mesh was observed to be lower compared with other experimental sites. Under the experimental condition, the result of this study suggests that titanium meshes with 50-μm-diameter pores were effective for guided bone regeneration in the early stage of healing.

元の言語英語
ページ(範囲)408-417
ページ数10
ジャーナルOdontology
105
発行部数4
DOI
出版物ステータス出版済み - 10 1 2017

Fingerprint

Bone Regeneration
Titanium
Canidae
Tomography
Bone and Bones
Transplants
Bicuspid
Osteogenesis
Bone Substitutes
Membranes
Cheek
Durapatite
Mandible
Bone Density
Dogs

All Science Journal Classification (ASJC) codes

  • Dentistry(all)

これを引用

@article{b796277e73d344108c551adf15845117,
title = "Micro-computed tomography analysis of early stage bone healing using micro-porous titanium mesh for guided bone regeneration: preliminary experiment in a canine model",
abstract = "The aim of this study was to evaluate the amount of bone formation beneath a defect area after treatment with titanium mesh membranes with different thicknesses and pore sizes alone or in combination with bone graft to induce bone formation during the early stage of healing time. The mandibular premolars were extracted bilaterally from three adult beagle dogs, and 8-mm-diameter bone defects were created on the buccal site of the premolar regions. Hydroxyapatite bone graft substitute was applied in the defect site unilaterally, and other site was left empty. Then, a novel micro-porous mesh (50 μm in pore diameter) or commercially available macro-porous titanium mesh (1700 μm in pore diameter) was placed on the defect and secured with screws. After 4 weeks, the mandibles were harvested, imaged using micro-computed tomography, and prepared for histological and morphometric evaluation. Higher new bone volumes (mm3), percentage of new bone volumes in the total defect volumes (bone ratio: {\%}), and new bone area (mm2) through morphometric evaluation were found on the novel membranes with 50-μm-diameter pores compared to the commercial titanium mesh. Moreover, experiment sites without bone graft were observed with higher new bone volume and bone ratio compared with sites with bone graft. However, bone mineral density of novel mesh was observed to be lower compared with other experimental sites. Under the experimental condition, the result of this study suggests that titanium meshes with 50-μm-diameter pores were effective for guided bone regeneration in the early stage of healing.",
author = "Rakhmatia, {Yunia Dwi} and Yasunori Ayukawa and Yohei Jinno and Akihiro Furuhashi and Kiyoshi Koyano",
year = "2017",
month = "10",
day = "1",
doi = "10.1007/s10266-017-0298-1",
language = "English",
volume = "105",
pages = "408--417",
journal = "Odontology / the Society of the Nippon Dental University",
issn = "1618-1247",
publisher = "Springer Japan",
number = "4",

}

TY - JOUR

T1 - Micro-computed tomography analysis of early stage bone healing using micro-porous titanium mesh for guided bone regeneration

T2 - preliminary experiment in a canine model

AU - Rakhmatia, Yunia Dwi

AU - Ayukawa, Yasunori

AU - Jinno, Yohei

AU - Furuhashi, Akihiro

AU - Koyano, Kiyoshi

PY - 2017/10/1

Y1 - 2017/10/1

N2 - The aim of this study was to evaluate the amount of bone formation beneath a defect area after treatment with titanium mesh membranes with different thicknesses and pore sizes alone or in combination with bone graft to induce bone formation during the early stage of healing time. The mandibular premolars were extracted bilaterally from three adult beagle dogs, and 8-mm-diameter bone defects were created on the buccal site of the premolar regions. Hydroxyapatite bone graft substitute was applied in the defect site unilaterally, and other site was left empty. Then, a novel micro-porous mesh (50 μm in pore diameter) or commercially available macro-porous titanium mesh (1700 μm in pore diameter) was placed on the defect and secured with screws. After 4 weeks, the mandibles were harvested, imaged using micro-computed tomography, and prepared for histological and morphometric evaluation. Higher new bone volumes (mm3), percentage of new bone volumes in the total defect volumes (bone ratio: %), and new bone area (mm2) through morphometric evaluation were found on the novel membranes with 50-μm-diameter pores compared to the commercial titanium mesh. Moreover, experiment sites without bone graft were observed with higher new bone volume and bone ratio compared with sites with bone graft. However, bone mineral density of novel mesh was observed to be lower compared with other experimental sites. Under the experimental condition, the result of this study suggests that titanium meshes with 50-μm-diameter pores were effective for guided bone regeneration in the early stage of healing.

AB - The aim of this study was to evaluate the amount of bone formation beneath a defect area after treatment with titanium mesh membranes with different thicknesses and pore sizes alone or in combination with bone graft to induce bone formation during the early stage of healing time. The mandibular premolars were extracted bilaterally from three adult beagle dogs, and 8-mm-diameter bone defects were created on the buccal site of the premolar regions. Hydroxyapatite bone graft substitute was applied in the defect site unilaterally, and other site was left empty. Then, a novel micro-porous mesh (50 μm in pore diameter) or commercially available macro-porous titanium mesh (1700 μm in pore diameter) was placed on the defect and secured with screws. After 4 weeks, the mandibles were harvested, imaged using micro-computed tomography, and prepared for histological and morphometric evaluation. Higher new bone volumes (mm3), percentage of new bone volumes in the total defect volumes (bone ratio: %), and new bone area (mm2) through morphometric evaluation were found on the novel membranes with 50-μm-diameter pores compared to the commercial titanium mesh. Moreover, experiment sites without bone graft were observed with higher new bone volume and bone ratio compared with sites with bone graft. However, bone mineral density of novel mesh was observed to be lower compared with other experimental sites. Under the experimental condition, the result of this study suggests that titanium meshes with 50-μm-diameter pores were effective for guided bone regeneration in the early stage of healing.

UR - http://www.scopus.com/inward/record.url?scp=85017119689&partnerID=8YFLogxK

UR - http://www.scopus.com/inward/citedby.url?scp=85017119689&partnerID=8YFLogxK

U2 - 10.1007/s10266-017-0298-1

DO - 10.1007/s10266-017-0298-1

M3 - Article

VL - 105

SP - 408

EP - 417

JO - Odontology / the Society of the Nippon Dental University

JF - Odontology / the Society of the Nippon Dental University

SN - 1618-1247

IS - 4

ER -