Optimization of microstructure and mechanical properties of Co-Cr-Mo alloys by high-pressure torsion and subsequent short annealing

Murat Isik, Mitsuo Niinomi, Huihong Liu, Ken Cho, Masaaki Nakai, Zenji Horita, Takayuki Narushima, Kyosuke Ueda

    研究成果: Contribution to journalArticle査読

    4 被引用数 (Scopus)

    抄録

    The main target of this study is to optimize the microstructure and to achieve an optimization for the mechanical properties in a biomedical Co-Cr-Mo (CCM) alloy with the nominal composition of Co-28Cr-6Mo (mass%) subjected to high-pressure torsion (HPT) and subsequent short annealing. The γ → ε phase transformation and grain refinement occur in the CCM alloy subjected to HPT processing at an equivalent strain (εeq) of 2.25 (CCMHPT). The HPT processing causes a decrease in the elongation due to the formation of an excessive amount of ε phase. For removal of the excessive amount of ε phases, the CCMHPT was subjected to a short annealing (CCMHPTA). The effect of the short annealing temperature (1073 K, 1273 K, and 1473 K; annealing time was fixed at 0.3 ks) on CCMHPT was investigated. In addition, the effect of the length of duration for the short annealing (0.06 ks, 0.3 ks, and 0.6 ks;) for a fixed annealing temperature of 1273 K on CCMHPT was studied. CCMHPTA(1273 K) annealed for 0.3 ks shows a good optimization of mechanical properties that include high strength and large elongation owing to its ultrafine-grained microstructure, and removal of excessive ε phases.

    本文言語英語
    ページ(範囲)1887-1896
    ページ数10
    ジャーナルMaterials Transactions
    57
    11
    DOI
    出版ステータス出版済み - 2016

    All Science Journal Classification (ASJC) codes

    • 材料科学(全般)
    • 凝縮系物理学
    • 材料力学
    • 機械工学

    フィンガープリント

    「Optimization of microstructure and mechanical properties of Co-Cr-Mo alloys by high-pressure torsion and subsequent short annealing」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

    引用スタイル