Production of aluminum-matrix carbon nanotube composite using high pressure torsion

Tomoharu Tokunaga, Kenji Kaneko, Zenji Horita

    研究成果: ジャーナルへの寄稿学術誌査読

    146 被引用数 (Scopus)

    抄録

    In this study, an Al-based composite containing carbon nanotubes (CNTs) was fabricated using a process of severe plastic deformation through high pressure torsion (HPT). Neither heating nor sintering was required with the HPT process so that an in situ consolidation was successfully achieved at ambient temperature with 98% of the theoretical density. A significant increase in hardness was recorded through straining by the HPT process. When the composite was pulled in tension, the tensile strength of more than 200 MPa was attained with reasonable ductility. Transmission electron microscopy showed that the grain size was reduced to ∼100 nm and this was much smaller than the grain size without CNTs and the grain size reported on a bulk sample. High resolution electron microscopy revealed that CNTs were present at grain boundaries. It was considered that the significant reduction in grain size is attributed to the presence of CNTs hindering the dislocation absorption and annihilation at grain boundaries.

    本文言語英語
    ページ(範囲)300-304
    ページ数5
    ジャーナルMaterials Science and Engineering A
    490
    1-2
    DOI
    出版ステータス出版済み - 8月 25 2008

    !!!All Science Journal Classification (ASJC) codes

    • 材料科学(全般)
    • 凝縮系物理学
    • 材料力学
    • 機械工学

    フィンガープリント

    「Production of aluminum-matrix carbon nanotube composite using high pressure torsion」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

    引用スタイル