Routing Methodology for Minimizing Crosstalk in SoC

Takashi Yamada, Atsushi Sakai, Yoshifumi Matsushita, Hiroto Yasuura

研究成果: ジャーナルへの寄稿記事

1 引用 (Scopus)

抄録

In this paper, we propose new physical design techniques to reduce crosstalk noise and crosstalk-induced delay variations caused in a nanometer-scale system-on-a-chip (SoC). We have almost eliminated the coupling effect between signal wires by simply optimizing parameters for the automatic place and route methodology. Our approach consists of two techniques, (1) A 3-D optimization technique for tuning the routing grid configuration both in the horizontal and vertical directions. (2) A co-optimization technique for tuning the cell utilization ratio and the routing grid simultaneously. Experiments on the design of an image processing circuit fabricated in a 0.13μm CMOS process with six layers of copper interconnect show that crosstalk noise is almost eliminated. From the results of a static timing analysis considering the worst-case crosstalk condition, the longest path delay is decreased by about 15% maximum if technique (1) is used, and by about 7% maximum if technique (2) is used. The 7-15% delay reduction has been achieved without process improvement, and this reduction corresponds to between 1/4 and 1/2 generation of process progress.

元の言語英語
ページ(範囲)2347-2356
ページ数10
ジャーナルIEICE Transactions on Fundamentals of Electronics, Communications and Computer Sciences
E86-A
発行部数9
出版物ステータス出版済み - 9 2003

Fingerprint

Crosstalk
Routing
Chip
Methodology
Optimization Techniques
Tuning
Grid
Timing Analysis
Process Improvement
Longest Path
Static Analysis
Interconnect
Copper
3D
Image Processing
Image processing
Horizontal
Atmospherics
Vertical
Wire

All Science Journal Classification (ASJC) codes

  • Electrical and Electronic Engineering
  • Hardware and Architecture
  • Information Systems

これを引用

Routing Methodology for Minimizing Crosstalk in SoC. / Yamada, Takashi; Sakai, Atsushi; Matsushita, Yoshifumi; Yasuura, Hiroto.

:: IEICE Transactions on Fundamentals of Electronics, Communications and Computer Sciences, 巻 E86-A, 番号 9, 09.2003, p. 2347-2356.

研究成果: ジャーナルへの寄稿記事

Yamada, Takashi ; Sakai, Atsushi ; Matsushita, Yoshifumi ; Yasuura, Hiroto. / Routing Methodology for Minimizing Crosstalk in SoC. :: IEICE Transactions on Fundamentals of Electronics, Communications and Computer Sciences. 2003 ; 巻 E86-A, 番号 9. pp. 2347-2356.
@article{f76bfce1961e4a32b55cb92060d51746,
title = "Routing Methodology for Minimizing Crosstalk in SoC",
abstract = "In this paper, we propose new physical design techniques to reduce crosstalk noise and crosstalk-induced delay variations caused in a nanometer-scale system-on-a-chip (SoC). We have almost eliminated the coupling effect between signal wires by simply optimizing parameters for the automatic place and route methodology. Our approach consists of two techniques, (1) A 3-D optimization technique for tuning the routing grid configuration both in the horizontal and vertical directions. (2) A co-optimization technique for tuning the cell utilization ratio and the routing grid simultaneously. Experiments on the design of an image processing circuit fabricated in a 0.13μm CMOS process with six layers of copper interconnect show that crosstalk noise is almost eliminated. From the results of a static timing analysis considering the worst-case crosstalk condition, the longest path delay is decreased by about 15{\%} maximum if technique (1) is used, and by about 7{\%} maximum if technique (2) is used. The 7-15{\%} delay reduction has been achieved without process improvement, and this reduction corresponds to between 1/4 and 1/2 generation of process progress.",
author = "Takashi Yamada and Atsushi Sakai and Yoshifumi Matsushita and Hiroto Yasuura",
year = "2003",
month = "9",
language = "English",
volume = "E86-A",
pages = "2347--2356",
journal = "IEICE Transactions on Fundamentals of Electronics, Communications and Computer Sciences",
issn = "0916-8508",
publisher = "Maruzen Co., Ltd/Maruzen Kabushikikaisha",
number = "9",

}

TY - JOUR

T1 - Routing Methodology for Minimizing Crosstalk in SoC

AU - Yamada, Takashi

AU - Sakai, Atsushi

AU - Matsushita, Yoshifumi

AU - Yasuura, Hiroto

PY - 2003/9

Y1 - 2003/9

N2 - In this paper, we propose new physical design techniques to reduce crosstalk noise and crosstalk-induced delay variations caused in a nanometer-scale system-on-a-chip (SoC). We have almost eliminated the coupling effect between signal wires by simply optimizing parameters for the automatic place and route methodology. Our approach consists of two techniques, (1) A 3-D optimization technique for tuning the routing grid configuration both in the horizontal and vertical directions. (2) A co-optimization technique for tuning the cell utilization ratio and the routing grid simultaneously. Experiments on the design of an image processing circuit fabricated in a 0.13μm CMOS process with six layers of copper interconnect show that crosstalk noise is almost eliminated. From the results of a static timing analysis considering the worst-case crosstalk condition, the longest path delay is decreased by about 15% maximum if technique (1) is used, and by about 7% maximum if technique (2) is used. The 7-15% delay reduction has been achieved without process improvement, and this reduction corresponds to between 1/4 and 1/2 generation of process progress.

AB - In this paper, we propose new physical design techniques to reduce crosstalk noise and crosstalk-induced delay variations caused in a nanometer-scale system-on-a-chip (SoC). We have almost eliminated the coupling effect between signal wires by simply optimizing parameters for the automatic place and route methodology. Our approach consists of two techniques, (1) A 3-D optimization technique for tuning the routing grid configuration both in the horizontal and vertical directions. (2) A co-optimization technique for tuning the cell utilization ratio and the routing grid simultaneously. Experiments on the design of an image processing circuit fabricated in a 0.13μm CMOS process with six layers of copper interconnect show that crosstalk noise is almost eliminated. From the results of a static timing analysis considering the worst-case crosstalk condition, the longest path delay is decreased by about 15% maximum if technique (1) is used, and by about 7% maximum if technique (2) is used. The 7-15% delay reduction has been achieved without process improvement, and this reduction corresponds to between 1/4 and 1/2 generation of process progress.

UR - http://www.scopus.com/inward/record.url?scp=1642313706&partnerID=8YFLogxK

UR - http://www.scopus.com/inward/citedby.url?scp=1642313706&partnerID=8YFLogxK

M3 - Article

VL - E86-A

SP - 2347

EP - 2356

JO - IEICE Transactions on Fundamentals of Electronics, Communications and Computer Sciences

JF - IEICE Transactions on Fundamentals of Electronics, Communications and Computer Sciences

SN - 0916-8508

IS - 9

ER -